Patriotic Firecracker Bow Tutorial

Patriotic Firecracker Bow DIY Tutorial

Finished

Materials Needed:
Grosgrain Ribbon (I used 3 colors in 3/8” solid and 2 colors in 7/8” polka dot)
Wire Garland of Your Choice
Glitter Tulle (or Regular Tulle)
Lined Double Prong Alligator Clip
Crystal Center Rhinestone Embellishment
String (I used crochet thread)
Scissors (not shown)
Needle and Thread (not Shown)
Glue Gun and Glue Stick (Not Shown)
Lighter (Not Shown)

Materials

Step One:
Start cutting your tulle into 5-6 5” strips. Lay them down in a rotating asterisk kind of pattern as shown below. Then, gather them in the middle, wrap your string around the center, and tie it off to make a bow-looking shape. Clip off the extra ends of your string once you have it secured.

Set this piece aside for now. We’ll come back to it.

StepOne

Step Two:
Cut your ribbon into 5.5” lengths. Then, shape the ends of them how you want them to look and use the lighter to seal the ends from fraying. Don’t hold the lighter too close or too long. I set one of mine on fire! Lol.

StepTwo

Step Three:
Stack your ribbons in crisscross patterns on top of one another. Make sure they all intersect in the center. This is important for the next part. I stacked the smaller width ones on top. Otherwise you won’t see them behind the bigger ones.

Once you have them all stacked together, use your needle and thread to sew a tack stitch in the center to hold them together.

StepThree

Step Four:
Cut a couple of strands of your wire garland to about the same length of the ribbons. Add them to your ribbon stack and tack stitch them into your bow as well. Once you feel like everything is tacked together securely, tie the stitch off in the back and clip the needle and extra string away.

StepFour

Step Five:
Going back to your tied tulle piece. Pull each of your ends around and out and up and down until you have made a shape that pleases you for the bottom of your bow. Then, using your scissors, trim off the excess length and shape it a bit.

StepFive

Step Six:
Squeeze a good glob of glue on the center of your tulle piece where your string is, and place your ribbon piece in the center of the glue. Hold it together for about 30 seconds to let it bond a bit. . I didn’t get a picture of this part. Sorry.

StepSix

Step Seven:
Hot glue the crystal center embellishment to the center of the bow (this will hide all of the stitching uglies).

StepSeven

Step Eight:
Hot glue the lined double prong alligator clip to the back center of the tulle piece.

StepEight

Voila! A fantastic hair clip for your patriotic princess, and it can be customized in any colors you like!

Finished

 

Don’t forget to check out our Facebook page for our 4th of July GIVEAWAY! We’ll be giving away this Firecracker Bow, our Patriotic Headband, and our Patriotic Flip Flops!

2 thoughts on “Patriotic Firecracker Bow Tutorial

Leave a Reply

Your email address will not be published. Required fields are marked *